408-10413 Datasheet, PDF (2/6 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

408-10413
2A
2B
Figure 2
1. Place the die half marked “TOP” into the upper
portion of the hand tool as shown in Figure 2A.
2. Slide the die toward the body of the tool until
the die retaining feature engages. There will be
an audible and tactile “click” when the die is
installed properly. See Figure 2B.
3. Place the second die half (as identified by the
color dot) in the moving jaw of the tool as shown
in Figure 2A.
4. Slide the die toward the body of the tool until
the die retaining feature engages. There will be
an audible and tactile “click” when the die is
installed properly. See Figure 2B.
4. NOTCHING THE CABLE (Figure 3)
The Cable Notching Tool (Figure 1) provides a
consistent and fast way to notch the ribbon cable.
After selecting the proper location for the notch,
proceed as follows:
1. Place the ribbon cable under the cable hold-
down feature and into the cable nest (Figure 3).
CAUTION
Make sure the cable is fully seated in the cable nest
to ensure the creation of a proper notch.
!
2. Squeeze the tool handles fully to notch the
cable.
To remove the dies, simply slide the dies away from
the body of the tool.
NOTE
i
Material removed from the cable will fall out of the
bottom of the tool.
Rev A
Cable Hold-Down
Feature
Cable Nest
Figure 3
2 of 6