408-10413 Datasheet, PDF (3/6 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

408-10413
Figure 4
5. CRIMPING PROCEDURE
5. Release the handles to open the hand tool.
The right-angle die set (yellow dot) is designed to
crimp the NEVALO Right-Angle Connector. The multi-
nest die set (blue dot) is designed to crimp the
NEVALO Feed-Thru Connector, Straight Connector,
and Terminator.
5.1. Crimping the Right-Angle Connector (Figure 4)
1. Install the right-angle die set (yellow dot) into
the hand tool as specified in Section 3.
2. Place the right-angle connector in the die set
nest with the cable insertion area facing away
from the body of the tool as shown in Figure 4.
6. Remove the crimped connector from the die
set.
5.2. Crimping the Feed-Thru Connector (Figure 5)
1. Install the multi-nest die set (blue dot) into the
hand tool as specified in Section 3.
2. Notch the ribbon cable as specified in
Section 4.
3. Place the cover half of the connector in the die
nest (Figure 5A).
3. Place the prepared ribbon cable fully into the
connector.
4. Squeeze the hand tool handles while keeping
the ribbon cable fully inserted into the connector.
NOTE
i
The TE logo should be facing the moving jaw of the
hand tool.
5A
5B
5C
Rev A
Figure 5
3 of 6