M02061 Datasheet, PDF (15/37 Pages) M/A-COM Technology Solutions, Inc. – 3.3 or 5 Volt Laser Driver

Pin Definitions
Table 2-1.
4x4 mm
QFN24 Pin
Number
14
M02061 Pin Definitions and Descriptions (5 of 7)
Pin Name
Pin equivalent load
Function
IBIAS_OUT
V_CC
IBIAS_OUT
Laser bias current output.
Connect directly to laser cathode or at higher bit rates through a ferrite or a
resistor to isolate the capacitance of this pin from the modulation drive,
(~2pF).
Maintain a voltage > 0.7V at this pin.
Connect 100 kΩ pullup resistor to VCC if pin 18 (SVCC) is used.
15
GND_O
V_CC
GND₀
Ground for output stage. May be connected directly to ground. At high bit
rates (>2Gb/s) an optional inductor or ferrite may be added to reduce
switching transients.
16
OUT+
V_CC
OUT+
Positive modulation current output. Sinks current when D_IN+ is HIGH.
Maintain a voltage > 1.6V at this pin when VCC3_SEL is high.
Maintain a voltage > 1.15V at this pin when VCC3_SEL is low.
17
OUT-
GND₀
See OUT+ drawing
Negative modulation current output. Sinks current when D_IN- is HIGH
Maintain a voltage > 1.6V at this pin when VCC3_SEL is high.
Maintain a voltage > 1.15V at this pin when VCC3_SEL is low.
02061-DSH-001-G
Mindspeed Technologies^®
15
Mindspeed Proprietary and Confidential