LTC3770_15 Datasheet, PDF (7/24 Pages) Linear Technology – Fast No RSENSE Step-Down Synchronous Controller with Margining, Tracking and PLL

TYPICAL PERFORMANCE CHARACTERISTICS
LTC3770
Current Limit Foldback
160
V_RNG = 1V
140
120
100
80
60
40
20
0
0 0.1 0.2 0.3 0.4
V_FB (V)
0.5 0.6
3770 G21
Ion Current vs V_IN
140
R_ON = 82k
120
100
80
60
40
20
0
0 5 10 15 20 25 30 35
INPUT VOLTAGE (V)
3770 G22
PIN FUNCTIONS ^{(UH Package/G Package)}
V_RNG (Pin 1/Pin 4): Sense Voltage Range Input. The
voltage at this pin is ten times the nominal sense voltage
at maximum output current and can be set from 0.5V to
2V by a resistive divider from INTV_CC. The nominal sense
voltage defaults to 50mV when this pin is tied to ground,
200mV when tied to INTV_CC. Do not set this voltage
between 0.5V to ground or 2V to INTV_CC.
V_FB (Pin 2/Pin 5): Error Amplifier Feedback Input. This pin
connects the error amplifier input to an external resistive
divider from V_OUT.
I_TH (Pin 3/Pin 6): Current Control Threshold and Error
Amplifier Compensation Point. The current comparator
threshold increases with this control voltage. The voltage
ranges from 0V to 2.4V with 0.75V corresponding to zero
sense voltage (zero current).
SGND (Pin 4/Pin 7): Signal Ground. All small-signal
components and compensation components should
connect to this ground, which in turn connects to PGND
at one point.
MARGIN1 (Pin 5/Pin 8): The MSB Logic Input for the
Margining Function. Together with the MARGIN0 pin
determines whether the IC is in margin high, margin low,
or no margin state. This pin has a 50k internal pull-down
resistor.
MARGIN0 (Pin 6/Pin 9): The LSB Logic Input for the
Margining Function. Together with the MARGIN1 pin
determines whether the IC is in margin high, margin low,
or no margin state. This pin has a 50k internal pull-down
resistor.
I_ON (Pin 7/Pin 10): On-Time Current Input. Tie a resistor
from this pin to ground to set the one-shot timer current
and thereby set the switching frequency.
V_REFIN (Pin 8/Pin 11): Error Amplifier Reference Input.
The voltage at this pin must be greater than 0.5V and
less than 1V.
V_REFOUT (Pin 9/Pin 12): Buffered Internal 0.6V Reference
Output. The maximum current sinking limit is 50μA at
this pin. Do not put a filter capacitor larger than 100pF
on this pin.
MPGM (Pin 10/Pin 13): Programmable Margining Input.
A resistor from this pin to ground sets the margining
current. This current, together with the resistor between
the V_REFOUT and V_REFIN pins, determines the margining
voltage offset.
TRACK/SS (Pin 11/Pin 14): Output Voltage Tracking and
Soft-Start Input. When the IC is configured to be the
master of two outputs, a capacitor to ground at this pin
3770fc
7