33621A Datasheet, PDF (18/24 Pages) Keysight Technologies – Trueform Waveform Generators

18 | Keysight | M33600A Series Trueform Waveform Generators - Data Sheet
Speciications
Modulating signals
Carrier
Sine
Sine
•
Square & pulse
•
Ramp & triangle
•
Gaussian noise
•
PRBS
•
Arbitrary
•
Square
•
•
•
•
•
•
Ramp
•
•
•
•
•
•
Triangle
•
•
•
•
•
•
Noise
•
•
•
•
•
PRBS
•
•
•
•
•
Arbitrary
•
•
•
•
•
External
•
•
•
•
•
•
Modulation, burst, and sweep characteristics
Amplitude modulation (AM)
Source
Internal or external (all models), or other channel (33612A/22A only)
Type
Full-Carrier or Double-Sideband Suppressed-Carrier (DSSC)
Depth ¹¹
Frequency modulation (FM) ¹²
0% to 120%, 0.01% resolution
Source
Internal or external (all models), or other channel (33612A/22A only)
Deviation
Phase modulation (PM)
1 µHz to 40 MHz (33611A/12A) or 60 MHz (33621A/22A), 1-µHz resolution
Source
Internal or external (all models), or other channel (33612A/22A only)
Deviation
0º to 360º, 0.1º resolution
Frequency-shift key modulation (FSK) ¹²
Source
Internal timer or rear-panel connector
Mark & space
Any frequency within the carrier signal’s range
Rate
≤ 1 MHz
Binary phase-shift key modulation (BPSK)
Source
Internal timer or rear-panel connector
Phase shift
0º to 360º, 0.1º resolution
Rate
≤ 1 MHz
Pulse-width modulation (PWM)
Source
Internal or external (all models), or other channel (33612A/22A only)
Deviation ⁶
Additive modulation (Sum)
0% to 100% of pulse width, 0.01% resolution
Source
Internal or external (all models), or other channel (33612A/22A only)
Ratio ¹¹
0% to 100% of carrier amplitude, 0.01% resolution
Burst characteristics ¹⁰
Type
Counted burst operation
Gated burst operation
Counted or gated
Each trigger event causes the instrument to produce from 1 to 10⁸ or an “ininite” number of waveform cycles.
Instrument produces waveforms while the trigger is in the “on” state. For Gaussian Noise, waveform generation stops
immediately when the trigger is in the “off” state. All other waveforms stop at the completion of a cycle; more than one
cycle might elapse before generation stops.
Start/stop phase
-360º to +360º, 0.1º resolution
Trigger source
Marker
Internal timer or rear-panel connector
Indicated by the trailing edge of the Sync pulse; adjustable to any cycle of the burst.
Footnotes referenced on page 22