N1923A Datasheet, PDF (11/19 Pages) Keysight Technologies – Wideband Power Sensors

11 | Keysight | 8990B Peak Power Analyzer and N1923A/N1924A Wideband Power Sensors - Data Sheet
8990B Peak Power Analyzer Specifications (Continued)
Time base
Range
Delta time accuracy
Timebase accuracy
Channel to channel offset
Delay range
Trigger
Hardware trigger
Sweep mode
Trigger mode
Trigger source
Trigger level
Level range
Level resolution
Level accuracy
Trigger delay
Delay range
Delay resolution
Trigger hold-off
Range
Resolution
Vertical and horizontal markers
Resolution
Sensor check source
Frequency
Power level
Signal type
Repetition rate
Connector type
SWR
Waveform measurement and math
Pulse measurement
Markers measurement
Waveform math
Statistical
Video averaging
Zoom
2 ns to 100 msec/div in 1-2-5 sequence or any arbitrary scaling, user defined
1 ns + 0.02 x (time/div)
± 1.4 ppm peak
± 5 ns (ETS Off), ± 3 ns (ETS On)
± 1 s max
Auto, triggered, single
Postive and negative edge, pulse width (all channels)
Trigger by event (sensor channel 1 and 4)
Channel 1, 2, 3, 4, AUX
Channel 1 and 4: –20 dBm to +20 dBm
Channel 2 and 3: ± 8 div from center screen (1 MΩ, edge mode)
AUX: TTL (high > 2.4 V, low < 0.7 V at 50 Ω
Channel 1 and 4: 0.01 dB
Channel 2 and 3: 10 µV ¹
Channel 1 and 4: ± 0.5 dB (0.5 dB/ns slew rate in ETS mode)
± 1.0 s max ²
1% of delay setting, 10 ns maximum (50 ns/div)
1 µs to 1 s
1% of selected value (to a minimum of 10 ns)
Minimum 1 ns
1.05 GHz or 50 MHz (selectable)
0 dBm ± 0.9% (50 MHz)
0 dBm ± 1.2% (1.05 GHz)
Square pulse modulated (1.05 GHz only) or CW (1.05 GHz or 50 MHz)
1 kHz
Type N (female)
1.05
Rise time, fall time, minimum, average, peak, peak-to-average, duty cycle, PRI, PRF, off time, pulse base, pulse top,
pulse width, overshoot
Delay measurement, pulse spacing, pulse droop
Add, averaging, common mode, divide, invert, magnify, multiply, PAE, PAE2, subtract, square root, XY display
CCDF (free run and triggered)
2, 4, 8, 32, 64, 128, 256, 512, 1024, 2048 selectable
Dual window zoom
1.  The trigger level of video channels is dependent on the vertical scale setting.
2.  The trigger delay range is dependant on the timebase setting.