FY0H104ZF_16 Datasheet, PDF (5/13 Pages) Kemet Corporation – Supercapacitors FY Series

Supercapacitors – FY Series
Specifications
Item
Category Temperature Range
Maximum Operating Voltage
Capacitance
Capacitance Allowance
ESR
Current (30 minutes value)
Capacitance
FY Type (FYD, FYH, FYL)
−25°C to +70°C
5.5 VDC
Refer to Table 1
+80%, −20%
Refer to Table 1
Refer to Table 1
> 90% of initial ratings
Surge
ESR
≤ 120% of initial ratings
Current (30 minutes value) ≤ 120% of initial ratings
Appearance
No obvious abnormality
Characteristics in
Different Temperature
Lead Strength (tensile)
Vibration Resistance
Capacitance
ESR
Capacitance
ESR
Capacitance
ESR
Current (30 minutes value)
Capacitance
ESR
Current (30 minutes value)
Capacitance
ESR
Current (30 minutes value)
Appearance
Phase 2
≥ 50% of initial value
≤ 400% of initial value
Phase 3
≤ 200% of initial value
Phase 5
Satisfy initial ratings
≤ 1.5 CV (mA)
Within ±20% of initial value
Phase 6
Satisfy initial ratings
Satisfy initial ratings
No terminal damage
Satisfy initial ratings
No obvious abnormality
Solderability
Over 3/4 of the terminal should be covered by the new
solder
Solder Heat Resistance
Capacitance
ESR
Current (30 minutes value)
Appearance
Satisfy initial ratings
No obvious abnormality
Test Conditions
(conforming to JIS C 5160-1)
Refer to “Measurement Conditions”
Refer to “Measurement Conditions”
Measured at 1 kHz, 10 mA; See also
“Measurement Conditions”
Refer to “Measurement Conditions”
Surge voltage:
Charge:
Discharge:
Number of cycles:
Series resistance:
Discharge
resistance:
Temperature:
6.3 V
30 seconds
9 minutes 30 seconds
1,000
0.010 F
1500
Ω
0.022 F
560 Ω
0.047 F
300 Ω
0.068 F
240 Ω
0.10 F
150 Ω
0.22 F
56 Ω
0.47 F
30 Ω
1.0 F, 1.4 F 15 Ω
2.2 F
10 Ω
0Ω
70±2°C
Conforms to 4.17
Phase 1:
Phase 2:
Phase 4:
Phase 5:
Phase 6:
+25±2°C
-25±2°C
+25±2°C
+70±2°C
+25±2°C
Conforms to 4.9
Conforms to 4.13
Frequency:
Testing Time:
10 to 55 Hz
6 hours
Conforms to 4.11
Solder temp: +245±5°C
Dipping time: 5±0.5 seconds
1.6 mm from the bottom should be dipped.
Conforms to 4.10
Solder temp: +260±10°C
Dipping time: 10±1 seconds
1.6 mm from the bottom should be dipped.
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • 864-963-6300 • www.kemet.com
S6015_FY • 10/6/2016 5