CA064X104K4GACTU Datasheet, PDF (5/18 Pages) Kemet Corporation – Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
Capacitor Array, C0G Dielectric, 10 – 200 VDC, (Commercial & Automotive Grade)
Electrical Parameters/Characteristics
Item
Parameters/Characteristics
Operating Temperature Range −55°C to +125°C
Capacitance Change with Reference to
+25°C and 0 VDC Applied (TCC)
±30 ppm/ºC
Aging Rate (Maximum % Capacitance Loss/Decade Hour)
1_{Dielectric Withstanding Voltage (DWV)}
2_{Dissipation Factor (DF) Maximum Limit at 25ºC}
0%
250% of rated voltage
(5±1 seconds and charge/discharge not exceeding 50 mA)
0.1%
3_{Insulation Resistance (IR) Limit at 25°C}
1,000 megohm microfarads or 100 GΩ
(Rated voltage applied for 120±5 seconds at 25°C)
1 _{DWV is the voltage a capacitor can withstand (survive) for a short period of time. It exceeds the nominal and continuous working voltage of the}
capacitor.
2 _{Capacitance and dissipation factor (DF) measured under the following conditions:}
1 MHz ±100 kHz and 1.0 Vrms ±0.2 V if capacitance ≤ 1,000 pF
1 kHz ±50 Hz and 1.0 Vrms ±0.2 V if capacitance > 1,000 pF
3 _{To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.}
Capacitance and Dissipation Factor (DF) measured under the following conditions:
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known
as Automatic Level Control (ALC). The ALC feature should be switched to "ON."
Post Environmental Limits
Dielectric
C0G
High Temperature Life, Biased Humidity, Moisture Resistance
Rated DC
Voltage
All
Capacitance
Value
All
Dissipation Factor Capacitance
(Maximum %)
Shift
0.5
0.3% or ±0.25 pF
Insulation
Resistance
10% of Initial
Limit
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • 864-963-6300 • www.kemet.com
C1016_C0G_ARRAY_SMD • 10/14/2016 5