IS62WV1288ALL Datasheet, PDF (8/15 Pages) Integrated Silicon Solution, Inc – 128K x 8 LOW VOLTAGE, ULTRA LOW POWER CMOS STATIC RAM

IS62WV1288ALL, IS62WV1288BLL
ISSI ^®
WRITE CYCLE SWITCHING CHARACTERISTICS^(1,2) (Over Operating Range)
Symbol
Parameter
45 ns
55 ns
70 ns
Min. Max.
Min. Max.
Min. Max.
Unit
tWC
Write Cycle Time
45 —
55 —
70 —
ns
tSCS1/tSCS2 CS1/CS2toWriteEnd
35 —
45 —
60 —
ns
tAW
Address Setup Time to Write End
35 —
45 —
60 —
ns
tHA
Address Hold from Write End
0—
0—
0
—
ns
tSA
Address Setup Time
0—
0—
0
—
ns
tPWE
WE Pulse Width
35 —
40 —
50 —
ns
tSD
Data Setup to Write End
20 —
25 —
30 —
ns
tHD
Data Hold from Write End
0—
0—
0
—
ns
tHZWE⁽³⁾
WE LOW to High-Z Output
— 20
— 20
— 20
ns
tLZWE⁽³⁾
WE HIGH to Low-Z Output
5—
5—
5
—
ns
Notes:
1. Test conditions assume signal transition times of 5 ns or less, timing reference levels of 0.9V/1.5V, input pulse levels of 0.4V
to VDD-0.2V/VDD-0.3V and output loading specified in Figure 1.
2. The internal write time is defined by the overlap of CS1 LOW, CS2 HIGH, and WE LOW. All signals must be in valid states to initiate a Write, but any one can go
inactive to terminate the Write. The Data Input Setup and Hold timing are referenced to the rising or falling edge of the signal that terminates the write.
3. Tested with the load in Figure 2. Transition is measured ±500 mV from steady-state voltage. Not 100% tested.
AC WAVEFORMS
WRITE CYCLE NO. 1 (CS1/CS2 Controlled, OE = HIGH or LOW)
ADDRESS
CS1
CS2
WE
DOUT
DIN
tWC
tSCS1
tHA
tSCS2
tAW
tPWE
tSA
tHZWE
DATA UNDEFINED
HIGH-Z
tLZWE
tSD
tHD
DATA-IN VALID
8
Integrated Silicon Solution, Inc. — www.issi.com — 1-800-379-4774
Rev. C
06/20/05