English
Language : 

ISL78200_14 Datasheet, PDF (8/22 Pages) Intersil Corporation – 2.5A Regulator with Integrated High-Side MOSFET for Synchronous Buck or Boost Buck Converter
ISL78200
Electrical Specifications Refer to the Block Diagram (page 4) and Typical Application Schematics (page 5). Operating conditions
unless otherwise noted: VIN = 12V, or VCC = 4.5V, TA = -40°C to +105°C. Typicals are at TA = +25°C.
Boldface limits apply over the operating temperature range, -40°C to +105°C. (Continued)
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
MAX
(Note 6) TYP (Note 6) UNITS
Minimum Output Voltage
0.5
V
Slew Rate
PFM MODE CONTROL
SR
CLOAD = 50pF
5
V/µs
Default PFM Current Threshold
MODE = VCC or floating
700
mA
INTERNAL HIGH-SIDE MOSFET
Upper MOSFET rDS(ON)
LOW-SIDE MOSFET GATE DRIVER
rDS(ON)_UP
(Note 7)
90 150 mΩ
LGATE Source Resistance
100mA Source Current
3.5
Ω
LGATE Sink Resistance
100mA Sink Current
3.3
Ω
BOOST CONVERTER CONTROL
EXT_BOOST Boost_Turn-Off Threshold Voltage
0.74 0.8 0.86 V
EXT_BOOST Hysteresis Sink Current
AUXVCC Boost Turn-Off Threshold Voltage
IAUXVCC_HYS
2.4 3.2 3.8 µA
0.74 0.8 0.86 V
AUXVCC Hysteresis Sink Current
POWER GOOD MONITOR
IAUXVCC_HYS
2.4 3.2 3.8 µA
Overvoltage Rising Trip Point
Overvoltage Rising Hysteresis
Undervoltage Falling Trip Point
Undervoltage Falling Hysteresis
PGOOD Rising Delay
PGOOD Leakage Current
PGOOD Low Voltage
PROTECTION
VFB/VREF
VFB/VOVTRIP
VFB/VREF
VFB/VUVTRIP
tPGOOD_DELAY
VPGOOD
Percentage of Reference Point
Percentage Below OV Trip Point
Percentage of Reference Point
Percentage Above UV Trip Point
fOSC = 500kHz
PGOOD HIGH, VPGOOD = 4.5V
PGOOD LOW, IPGOOD = 0.2mA
104 110 116 %
3
%
84
90
96
%
3
%
2
ms
10
nA
0.10
V
Default Cycle by Cycle Current Limit Threshold
Hiccup Current Limit Threshold
OVERVOLTAGE PROTECTION
IOC_1
IOC_2
ILIMIT = GND or VCC or Floating
Hiccup, IOC_2/IOC_1
3
3.6 4.2
A
115
%
OV Latching-off Trip Point
Percentage of Reference Point
LG = UG = LATCH LOW
120
%
OV Non-Latching-off Trip Point
Percentage of Reference Point
LG = UG = LOW
110
%
OV Non-Latching-off Release Point
Percentage of Reference Point
102.5
%
OVER-TEMPERATURE PROTECTION
Over-Temperature Trip Point
155
°C
Over-Temperature Recovery Threshold
140
°C
NOTES:
6. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
7. Wire bonds not included. The wire bond resistance between VIN and PHASE pin is 32mΩ typical.
8
FN7641.2
December 24, 2013