ISL1539A_14 Datasheet, PDF (6/23 Pages) Intersil Corporation – Dual Port VDSL2 Line Driver

ISL1539A
Electrical Specifications V_S = ±12V, R_L= 100Ω differential, I_ADJ = C₀ = C₁ = 0V, A_V = 10V/V, R_F = 3.2kΩ,
T_A = +25°C. Amplifier pairs tested separately unless otherwise indicated. (Continued)
PARAMETER
DESCRIPTION
CONDITIONS
MIN
TYP
MAX
UNIT
I_OUT
Peak Output Current
INPUT CHARACTERISTICS
V_OUT = ±1V, R_L = 1Ω
±600
mA
V_OS
ΔV_OS
Input Offset Voltage
Input V_OS Mismatch
Between Amplifiers for Each
Port
-8
+3.5
+8
mV
-2
0
+2
mV
V_{OS, DRIFT}
I_B+
Input V_OS Drift
Non-Inverting Input Bias
Current
-25°C to +125°C T_J
±15
µV/°C
-8
+8
µA
ΔI_B+
Non-Inverting I_B+ Mismatch
Between Amplifiers for Each
Port
-2
+2
µA
I_B+_{, DRIFT}
I_B-
ΔI_B-
Non-Inverting I_B+ Drift
-25°C to +125°C T_J
Inverting Input Bias Current
Inverting I_B- Mismatch
Between Amplifiers for Each
Port
±12
nA/°C
-75
+75
µA
-35
+35
µA
I_B-_{, DRIFT}
CMIR
Inverting I_B- Drift
Common Mode Input Range
at each of the 4
Non-Inverting Input Pins
-25°C to +125°C T_J
±25
±7.5
nA/°C
V
CMRR
Common Mode Rejections for V_CM to Differential Mode Output
each Port. V_CM = -5V to +5V (Input Referred)
V_CM to Commonl Mode Output
(Output Referred)
80
dB
43
dB
PSRR
Power Supply Rejections for +V_S = +7.5V to +12V, -V_S = -12V
97
dB
each Port to Differential
Output (Input Referred)
-V_S = -7.5V to -12V, +V_S = +12V
92
dB
Power Supply Rejections for +V_S = +7.5V to +12V, -V_S = -12V
51
dB
each Port to Common Mode
Output (Output Referred)
-V_S = -7.5V to -12V, +V_S = +12V
45
dB
NOTES:
6. Active Termination Test Circuit. Low Power Mode (see Figure 45).
7. The -V_S supply current is the +V_S supply current minus the ground current, except power down condition.
6
FN6916.0
September 23, 2009