ISL70419SEH Datasheet, PDF (4/22 Pages) Intersil Corporation – Spectral analysis equipment

ISL70419SEH
Absolute Maximum Ratings
Maximum Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42V
Maximum Supply Voltage (LET = 86.4 MeV•cm²/mg). . . . . . . . . . . . . 36V
Maximum Differential Input Current . . . . . . . . . . . . . . . . . . . . . . . . . . 20mA
Maximum Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20V
Min/Max Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . V- - 0.5V to V+ + 0.5V
Max/Min Input current for Input Voltage >V+ or <V-. . . . . . . . . . . . . . . . ±20mA
Output Short-Circuit Duration (1 output at a time). . . . . . . . . . . . . . . . Indefinite
ESD Rating
Human Body Model (Tested per MIL-PRF-883 3015.7). . . . . . . . . . . 2kV
Machine Model (Tested per EIA/JESD22-A115-A) . . . . . . . . . . . . . . 200V
Charged Device Model (Tested per JESD22-C101D) . . . . . . . . . . . . 750V
Thermal Information
Thermal Resistance (Typical)
_JA (°C/W) _JC (°C/W)
14 Ld Flatpack (Notes 3, 4). . . . . . . . . . . . .
35
8
Maximum Storage Temperature Range . . . . . . . . . . . . . .-65°C to +150°C
Maximum Junction Temperature (T_JMAX) . . . . . . . . . . . . . . . . . . . . .+150°C
Pb-Free Reflow Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . see TB493
Recommended Operating Conditions
Ambient Operating Temperature Range . . . . . . . . . . . . . .-55°C to +125°C
Maximum Operating Junction Temperature . . . . . . . . . . . . . . . . . .+150°C
Supply Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10V (±5V) to 30V (±15V)
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
3. _JA is measured in free air with the component mounted on a high effective thermal conductivity test board with “direct attach” features. See Tech
Brief TB379.
4. For _JC, the "case temp" location is the center of the package underside.
Electrical Specifications V_S ± 15V, V_CM = 0, V_O = 0V, T_A = +25°C, unless otherwise noted. Boldface limits apply across the operating
temperature range, -55°C to +125°C; over a total ionizing dose of 300krad(Si) with exposure at a high dose rate of 50 - 300rad(Si)/s; or across a total
ionizing dose of 50krad(Si) with exposure at a low dose rate of <10mrad(Si)/s.
PARAMETER
DESCRIPTION
TEST CONDITIONS
MIN
MAX
(Note 5) TYP (Note 5) UNITS
V_OS
Input Offset Voltage
10
85
µV
110
µV
TCV_OS
I_B
Offset Voltage Drift
Input Bias Current
guaranteed by characterization not tested
-2.5
T_A = -55°C to +125°C
-5
over high and low dose radiation
-15
0.1
0.08
1
µV/°C
2.5
nA
5
nA
15
nA
TCI_B
Input Bias Current Temperature
Coefficient
guaranteed by characterization not tested
-5
1
5
pA/°C
I_OS
Input Offset Current
T_A = -55°C to +125°C
over high and low dose radiation
-2.5
0.08
2.5
nA
-3
3
nA
-10
10
nA
TCI_OS
Input Offset Current Temperature
Coefficient
guaranteed by characterization not tested
-3
0.42
3
pA/°C
V_CM
CMRR
Input Voltage Range
Common-Mode Rejection Ratio
guaranteed by CMRR test
V_CM = -13V to +13V
-13
13
V
120
145
dB
120
dB
PSRR
Power Supply Rejection Ratio
V_S = ±2.25V to ±20V
120
145
dB
120
dB
A_VOL
V_OH
Open-Loop Gain
Output Voltage High
V_O = -13V to +13V, R_L = 10k to ground
R_L = 10k to ground
3,000
13.5
13.2
14,000
13.7
V/mV
V
V
R_L = 2k to ground
13.3
13.55
V
13.0
V
Submit Document Feedback
4
July 11, 2014
FN8653.0