DG406_06 Datasheet, PDF (4/13 Pages) Intersil Corporation – Single 16-Channel/Differential 8-Channel, CMOS Analog Multiplexers

DG406, DG407
Absolute Maximum Ratings
V+ to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.0V
GND to V-. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25V
Digital Inputs, V_S, V_D (Note 1). . . . . . (V-) -2V to (V+) +2V or 20mA,
Whichever Occurs First
Continuous Current (Any Terminal) . . . . . . . . . . . . . . . . . . . . . 30mA
Peak Current, S or D (Pulsed 1ms, 10% Duty Cycle Max) . . . . . 100mA
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . -40^oC to 85^oC
Thermal Information
Thermal Resistance (Typical, Note1)
θ_JA (^oC/W)
PDIP Package*. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
60
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
75
Maximum Junction Temperature . . . . . . . . . . . . . . . . . . . . . . .150^oC
Maximum Storage Temperature Range . . . . . . . . . . -65^oC to 150^oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300^oC
(PLCC and SOIC - Lead Tips Only)
*Pb-free PDIPs can be used for through hole wave solder processing
only. They are not intended for use in Reflow solder processing
applications.
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. θ_JA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
2. Signals on S_X, D_X, EN or A_X exceeding V+ or V- are clamped by internal diodes. Limit diode current to maximum current ratings.
Electrical Specifications Test Conditions: V+ = +15V, V- = -15V, V_AL = 0.8V, V_AH = 2.4V Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
(NOTE 3) (NOTE 4) (NOTE 3)
TEMP (^oC)
MIN
TYP
MAX
DYNAMIC CHARACTERISTICS
Transition Time, t_TRANS
(See Figure 1)
25
-
200
300
Full
-
-
400
Break-Before-Make Interval, t_OPEN
(See Figure 3)
25
25
50
-
Full
10
-
-
Enable Turn-ON Time, t_ON(EN)
(See Figure 2)
25
-
150
200
Full
-
-
400
Enable Turn-OFF Time, t_OFF(EN)
25
-
Full
-
70
150
-
300
Charge Injection, Q
OFF Isolation, OIRR
C_L = 1nF, V_S = 0V, R_S = 0Ω
25
-
40
-
V_EN = 0V, R_L = 1kΩ,
f = 100kHz (Note 7)
25
-
-69
-
Logic Input Capacitance, C_IN
Source OFF Capacitance, C_S(OFF)
f = 1MHz
V_EN = 0V, V_S = 0V,
f = 1MHz
25
-
7
-
25
-
8
-
Drain OFF Capacitance, C_D(OFF)
DG406
V_EN = 0V, V_D = 0V,
f = 1MHz
25
-
160
-
DG407
25
-
80
-
Drain ON Capacitance, C_D(ON)
DG406
V_EN = 5V, V_D = 0V,
f = 1MHz
25
-
180
-
DG407
25
-
90
-
DIGITAL INPUT CHARACTERISTICS
Logic High Input Voltage, V_INH
Logic Low Input Voltage, V_INL
Logic High Input Current, I_AH
Logic Low Input Current, I_AL
ANALOG SWITCH CHARACTERISTICS
V_A = 2.4V, 15V
V_EN = 0V, 2.4V, V_A = 0V
Full
2.4
-
-
Full
-
-
0.8
Full
-1
-
1
Full
-1
-
1
Drain-Source ON Resistance, r_DS(ON)
V_D = ±10V, I_S = +10mA (Note 5)
25
-
Full
-
50
100
-
125
r_DS(ON) Matching Between Channels,
∆r_DS(ON)
V_D = 10V, -10V (Note 6)
25
-
5
-
UNITS
ns
ns
ns
ns
ns
ns
ns
ns
pC
dB
pF
pF
pF
pF
pF
pF
V
V
µA
µA
Ω
Ω
%
4
FN3116.9
March 13, 2006