English
Language : 

HCA10014 Datasheet, PDF (2/17 Pages) Intersil Corporation – 15MHz, BiMOS Operational Amplifier with MOSFET Input/CMOS Output
HCA10014
Absolute Maximum Ratings
DC Supply Voltage (Between V+ and V- Terminals) . . . . . . . . . .16V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8V
DC Input Voltage . . . . . . . . . . . . . . . . . . . . . . (V+ +8V) to (V- -0.5V)
Input Terminal Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1mA
Output Short Circuit Duration (Note 1). . . . . . . . . . . . . . . . Indefinite
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . -50oC to 125oC
Thermal Information
Thermal Resistance (Typical, Note 2)
θJA (oC/W)
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
160
Maximum Junction Temperature (Metal Can Package) . . . . . . .175oC
Maximum Junction Temperature (Plastic Package) . . . . . . . .150oC
Maximum Storage Temperature Range . . . . . . . . . . -65oC to 150oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Short circuit may be applied to ground or to either supply.
2. θJA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications TA = 25oC, V+ = 15V, V- = 0V, Unless Otherwise Specified
PARAMETER
SYMBOL
TEST
CONDITIONS
MIN
TYP
MAX
UNITS
Input Offset Voltage
Input Offset Voltage Temperature Drift
Input Offset Current
Input Current
Large Signal Voltage Gain
|VIO|
∆VIO/∆T
|IIO|
II
AOL
VS = ±7.5V
VS = ±7.5V
VS = ±7.5V
VO = 10VP-P, RL = 2kΩ
-
8
15
mV
-
10
-
µV/oC
-
0.5
30
pA
-
5
50
pA
50
320
-
kV/V
94
110
-
dB
Common Mode Rejection Ratio
CMRR
70
90
-
dB
Common Mode Input Voltage Range
Power Supply Rejection Ratio
Maximum Output Voltage
Maximum Output Current
Supply Current
VICR
∆VIO/∆VS VS = ±7.5V
VOM+
RL = 2kΩ
VOM-
VOM+
VOM-
RL = 2kΩ
RL = ∞
RL = ∞
IOM+ (Source) at VO = 0V
IOM- (Sink) at VO = 15V
I+
VO = 7.5V, RL = ∞
I+
VO = 0V, RL = ∞
0
-0.5 to 12
10
-
32
320
12
13.3
-
-
0.002
0.01
14.99
15
-
-
0
0.01
12
22
45
12
20
45
-
10
15
-
2
3
V
µV/V
V
V
V
V
mA
mA
mA
mA
2