FMCE-0528 Datasheet, PDF (8/10 Pages) Interpoint Corporation Company – Attenuation to 60 dB at 500 kHz, typical Operating temperature -55° to +125°C

Crane Aerospace & Electronics Power Solutions
FMCE-0528 EMI Input Filters
28 Volt Input – 5 Amp
BOTTOM VIEW CASE K2
Flanged cases: Designator “F” required in Case Option position of model number.
Seam Seal 0.040 dia
(1.02)
1.115 max. (28.32)
0.955 (24.26)
0.555 (14.1)
0.155 (3.94)
0.000
Dot on top of case indicates pin one
1
2
3
5
4
0.162 dia
(4.11)
2.910 max
(73.91)
Flange thickness: 0.060 (1.52)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold, cceramic seal.
Seal Hole: 0.120 ±0.002 (3.04 ±0.05)
Case K1 FMC F, Rev E, 20091111
Please refer to the numerical dimensions for accuracy. All information is believed to
be accurate, but no responsibility is assumed for errors or omissions. Interpoint
reserves the right to make changes in products or specifications without notice.
Copyright © 1999-2009 Interpoint Corp. All rights reserved.
Figure 10: Case K2
www.interpoint.com
Page 8 of 10
FMCE-0528 Rev D - 20100413