FMCE-0528 Datasheet, PDF (7/10 Pages) Interpoint Corporation Company – Attenuation to 60 dB at 500 kHz, typical Operating temperature -55° to +125°C

Crane Aerospace & Electronics Power Solutions
FMCE-0528 EMI Input Filters
28 Volt Input – 5 Amp
BOTTOM VIEW CASE H1
Seam Seal
0.040 dia
(1.02)
1.115 max. (28.32)
0.955 (24.26)
Squared corner and dot on top
of case indicate pin one.
1
2
3
0.555 (14.1)
5
4
0.155 (3.94)
0.000
Seal hole: 0.120 ±0.002 (3.05 ±0.05)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold, ceramic seal
Seal hole 0.120 ±0.002 (2.34 ± 0.05)
Case H1 Filters, Rev E, 20100316
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2009 Interpoint Corp. All rights reserved.
Figure 9: Case H1
www.interpoint.com
Page 7 of 10
FMCE-0528 Rev D - 20100413