FME270-461_10 Datasheet, PDF (7/11 Pages) Interpoint Corporation Company – Attenuation to 50 dB at 500 kHz Operating temperature -55° to +125°C

Crane Aerospace & Electronics Power Solutions
FME270-461 EMI Input Filters – Cases
270 Volt Input – 1.5 Amp
TOP VIEW CASE V*
Flanged case, down leaded
*Designator "V" required in Case Option position of model number.
Angled corner
indicates pin one.
1.380 (35.05)
1.250 (31.75)
1.050 (26.67)
0.850 (21.59)
0.650 (16.51)
0.450 (11.43)
0.250 (6.35)
0.120 (3.05)
0.000
Maximum dimensions: 3.005 x 1.505 (76.33 x 38.23 mm)
3.45 (87.6) Reference
(lead center to lead center)
1
12
2
11
3
10
4
9
5
8
6
7
0.128 dia
(3.25)
0.040 dia
(1.02)
Seam Seal
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device. Solder pins
individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold, compresssion glas seal
Seal Hole: 0.120 ±0.002 (3.05 ±0.05)
Case V, Rev E, 20100106
Please refer to the numerical dimensions for accuracy. All information is believed to
be accurate, but no responsibility is assumed for errors or omissions. Interpoint
reserves the right to make changes in products or specifications without notice.
Copyright © 1999-2009 Interpoint Corp. All rights reserved.
Figure 5: Case V - FME270-461V
www.interpoint.com
Page 7 of 11
FME270 Rev B - 20100226