FME270-461_10 Datasheet, PDF (11/11 Pages) Interpoint Corporation Company – Attenuation to 50 dB at 500 kHz Operating temperature -55° to +125°C

Crane Aerospace & Electronics Power Solutions
FME270-461 EMI Input Filters
270 Volt Input – 1.5 Amp
STANDARD AND /ES (NON-QML) PRODUCTS
ENVIRONMENTAL SCREENING ¹
test perFOrmed
Pre-cap Inspection
Method 2017, 2032
Temperature Cycle (10 times)
Method 1010, Cond. B, -55°C to +125°C, ambient
Constant Acceleration
Method 2001, 500 g
Burn-in
Method 1015 ³
96 hours
Final Electrical Test MIL-PRF-38534, Group A
Subgroups 1 and 4: +25°C case
Hermeticity Test
Fine Leak, Method 1014, Cond. A
Gross Leak, Method 1014, Cond. C
Gross Leak, Dip (1 x 10^-3)
Final visual inspection
Method 2009
standard
nOn-Qml²
yes
no
no
no
yes
no
no
yes
yes
/es
nOn-Qml²
yes
yes
yes
yes
yes
yes
yes
no
yes
Test methods are referenced to MIL-STD-883 as determined by MIL-PRF-38534.
Notes:
1. refers to products that do not offer QMl screening.
2. Standard and /ES, non-QML products, do not meet all of the requirements of MIL-PRF-38534.
3. Burn-in designed to bring the case temperature to the maximum case temperature of the product. Refer to the specific product information
for the maximum case temperature.
FME270-461 EMI Input Filters FME270 Rev B - 20100226. This revision supersedes all previous releases. All technical information is believed to be
accurate, but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make changes in products or specifications without notice.
FME270 Series EMI Filters are a trademark of Interpoint. Copyright © 1999 - 2010 Interpoint Corporation. All rights reserved. www.interpoint.com
Page 11 of 11