HR150 Datasheet, PDF (6/7 Pages) Interpoint Corporation Company – -40°C to +85°C operation Transient protection 50 V for 50 ms

DC/DC Converters
BOTTOM VIEW CASE H6
Solder Seal
1.120 (28.45)
0.960 (24.38)
0.040 dia
(1.02)
Solder Tip-off
0.160 (4.06)
0.000
Dot on top of case indicates pin one
1
2
3
4
5
10
9
8
7
6
hr150
series
20 Watt
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Tin
Cover Cold Rolled Steel/Nickel/Tin
Pins
#52 alloy, compression glass seal or ceramic seal
Case H6, Rev D, 20100211
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2010 Interpoint Corp. All rights reserved.
Figure 4: Case H6 – HR151 and HR152
www.interpoint.com
Page ­6­­ of 7
HR150 Rev E 20100212