HR150 Datasheet, PDF (5/7 Pages) Interpoint Corporation Company – -40°C to +85°C operation Transient protection 50 V for 50 ms

DC/DC Converters
BOTTOM VIEW CASE F4
Solder Seal
1.350 max (4.39)
Squared corner and dot on top
of case indicate pin one.
1.173
(29.79)
1
2
3
4
5
0.040 dia.
(1.02)
Solder Tip-off
10
9
8
7
6
0.173
(4.39)
0.000
hr150
series
20 Watt
Seal hole: 0.083 ±0.003 (2.11 ±0.08)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Tin
Cover Cold Rolled Steel/Nickel/Tin
Pins
#52 alloy, compression glass seal or ceramic seal
Case F4, Rev C, 20060802
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
Figure 3: Case F4 – HR153
www.interpoint.com
Page ­5­­ of 7
HR150 Rev E 20100212