SLH28 Datasheet, PDF (4/12 Pages) Interpoint Corporation Company – SLH Single and Dual DC-DC Converters

Crane Aerospace & Electronics Power Solutions
SLH Single and Dual DC-DC Converters
28 Volt input – 1.5 Watt
Table 5: Operating Conditions - All Models, 25°C case, 28 volts Vin, unless otherwise specified
PARAMETER
LEAD SOLDERING TEMPERATURE ¹
STORAGE TEMPERATURE
CASE OPERATING
TEMPERATURE
DERATING OUTPUT POWER/CURRENT ¹
ESD RATING ¹
MIL-PRF-38534, 3.9.5.8.2
ISOLATION, Input to Output or
ANY PIN TO CASE Except case pin
INPUT TO OUTPUT CAPACITANCE ¹
CONVERSION FREQUENCY
-55° TO +125°C
INHIBIT ACTIVE LOW (OUTPUT DISABLED)
Do not apply a voltage to the inhibit pin ²
INHIBIT ACTIVE HIGH (OUTPUT ENABLED)
Do not apply a voltage to the inhibit pin ²
CONDITIONS
10 seconds max.
FULL POWER
ABSOLUTE ¹
LINEARLY
MIL-STD-883 Method 3015
Class 3B
@ 500 VDC at 25°C
5, 12, 15, ±5 and ±15
±12
inhibit pin pulled low
INHIBIT PIN SOURCE
CURRENT ¹
REFERENCED TO
INHIBIT PIN CONDITION
OPEN INHIBIT PIN
VOLTAGE ¹
All Models
MIN
TYP
MAX UNITS
—
—
300
°C
-65
—
+150
°C
-55
—
+125
°C
-55
—
+135
From 100% at 125°C to 0% at 135°C
—
­—
≥8000
V
100
—
— Megohms
— 100 - 170 —
pF
220
280
320
kHz
220
—
420
—
—
0.5
V
—
—
2
mA
INPUT COMMON
OPEN COLLECTOR OR
UNCONNECTED
7
—
8
V
For mean time between failures (MTBF) contact Applications Engineering
[e-mail] [phone] option 7
Notes:
1. Guaranteed by qualification test and/or analysis. Not an in-line test.
2. An external inhibit interface should be used to pull the inhibit low or leave it floating. The inhibit pin can be left unconnected if not used. Do not
apply an external pull-up.
www.craneae.com/interpoint
Page 4 of 12
SLH Rev AB - 2015.10.22