FMGA-461_15 Datasheet, PDF (11/14 Pages) Interpoint Corporation Company – FMSA/FMGA EMI Input Filters 28 Volt Input - 0.8 AMP

Crane Aerospace & Electronics Power Solutions
FMSA/FMGA EMI Input Filters
28 Volt Input - 0.8 AMP
BOTTOM VIEW CASE A1 FMSA
Projection Weld
0.805 max. (20.45)
0.697 (17.70)
0.397 (10.08)
0.097 (2.46)
0.000
Squared corner and dot on
top of case indicate pin one.
1
23
8
4
7
65
0.018 ± 0.002 dia.
(0.46 ± 0.05)
Seal hole: 0.056 ±0.002 (1.42 ±0.05)
Weight: 11.5 grams maximum
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding
300°C for 10 seconds per pin.
Materials
Header Kovar/Nickel/Gold
Cover Kovar/Nickel
Pins Kovar/Nickel/Gold matched glass seal
Gold plating of 50 microinches minimum
Case A1 FMSA, Rev E, 2015.12.14
Please refer to the numerical dimensions for accuracy.
Figure 15: Case A1
www.craneae.com/interpointcom
Page 11 of 14
FMSA/FMGA Rev AA - 2015.12.15