GD82559C Datasheet, PDF (11/60 Pages) Intel Corporation – Intel-Based Electronic Classroom Student Computing Station Based on the Intel® Celeron™ Processor and Intel® 810 Chipset

4.0
Intel-Based Electronic Classroom Student Computing Station
Recommended Motherboard Configuration for
Intel-Based Electronic Classroom Student
Computing Stations
The motherboard of this reference design for Intel-based electronic classroom student computing
stations is a highly integrated design that incorporates many features on the board. It is
recommended that system designers use an LPX form factor or Flex ATX design. The LPX form
factor enables the student computing stations to have a very slim casing, which is desirable for
small Intel-based electronic classroom environments. Flex ATX helps reduce board size and cost.
The components listed below provide an example of a motherboard design based on the Celeron
processor and Intel 810 chipset.
Main Components of Reference Motherboard for the Intel-Based Electronic Classroom
Student Computing Station:
• Intel^® Celeron™ processor 300A/366/433 MHz in 370-pin PPGA
• Intel^® 810 Chipset
• Two DIMM sockets that support up to 512 Mbyte (128 Mbit technology) SDRAM
• Two IDE interfaces
• One floppy disk interface
• COM 1 and COM 2 serials ports and a parallel port
• PS/2 mouse and keyboard connectors
• Intel^® Flash BIOS
• Super I/O* and USB ports
• 1 X PCI 2.2-compliant PCI slot
Peripherals on Intel-Based Electronic Classroom Student Computing Station:
Integrated audio in chipset
• Audio Codec ’97 2.1 extensions compliant
• Stereo line level output
• One audio out, audio in, and MIC jack
Integrated Graphics
• 3-D graphics with texturing and visual enhancements up to 1024x768x16 @85 Hz refresh
• 2-D graphics up to 1600x1200x8 @85 Hz refresh
• RGB output
PCI-based 10/100 Mbps Network card
• Intel^® 82559-based card recommended
• One RJ-45 port
• Boot ROM which contains Intel^® Preboot Execution Environment (PXE)
Application Note
11