English
Language : 

TLE7258D_15 Datasheet, PDF (6/31 Pages) Infineon Technologies AG – TLE7258D
TLE7258D
Functional Description
4
Functional Description
The LIN interface is a single wire, bi-directional bus, used for in-vehicle networks. The TLE7258D LIN transceiver
is the interface between the microcontroller and the physical LIN Bus (see Figure 15). Data from the
microcontroller is driven to the LIN bus via the TxD input of the TLE7258D. The transmit data stream on the TxD
input is converted to a LIN bus signal with optimized slew rates in order to minimize the electromagnetic emission
level of the LIN network. The RxD output reads back the information from the LIN bus to the microcontroller. The
receiver has an integrated filter network to suppress noise from the LIN bus and to increase the electromagnetic
immunity level of the transceiver.
The LIN specification defines two valid bus states (see Figure 3):
• “Dominant” state with the LIN bus voltage level near GND.
• “Recessive” state with the LIN bus voltage pulled up to the supply voltage VS through the bus termination.
By setting the TxD input of the TLE7258D to a logical “low” signal, the transceiver generates a “dominant” level on
the BUS interface pin. The receiver reads back the signal on the LIN bus and indicates the “dominant” LIN bus
signal with a logical “low” level on the RxD output to the microcontroller. By setting the TxD input to logical “high”,
the transceiver sets the LIN interface pin to the “recessive” level. At the same time the “recessive” level on the LIN
bus is indicated by a logical “high” level on the RxD output.
Every LIN network consists of a master node and one or more slave nodes. To configure the TLE7258D for master
node applications, a termination resistor of 1 kΩ and a diode must be connected between the LIN bus and the
power supply VS (see Figure 15).
VCC
TxD
VS
BUS
Recessive
Vth_DOM
VCC
RxD
Figure 3 LIN bus signals
Dominant
t
Recessive
Vth_REC
t
t
TLE7258_LIN_COMMUNICATION
Data Sheet
6
Rev. 1.2, 2014-12-08