TLE7184F_15 Datasheet, PDF (37/38 Pages) Infineon Technologies AG – System IC for B6 motor drives

TLE7184F
12
Revision History
Revision History
Revision
Rev. 1.1
Rev.1.0
Date
2011-04-08
2008-12-04
Changes
- Voltage difference between ISP and ISN specified
- Minimum buffer capacitor C_VREG specified
- Description of SH currents added
- Fig. 4 new
- Pull up and pull down resistors at IHx and ILx expanded
- Rise and fall times specified
- Propagation time tolerance reduced
- Limit the lower load current of VDD to 2mA
- Fig. 5 updated
- Steady state differential input voltage range across VIN removed
- Common mode suppression, footnote added
- IFMA low time to guarantee wake-up added
- Matching of IFMA pull up / pull down resistors replaced by
IFMA input current / VS
- Pull up resistor at IFuC output expanded
- Pull up resistor at INHD expanded
- High level input voltage INH (for INHD=high) adapted
- Dead time description improved
- Short circuit detection accuracy improved
- SCDL open pin detection level hysteresis, footnote added
- Rise time ERR adapted
- Pull down resistor at ERR output expanded
- INH high time to guarantee wake-up added
- Analog temperature output tolerance at 25°C improved
- Test conditions of bias current into BHx modified
- Current between BHx and SHx adapted
- IFMA internal pull-up resistor to VS modified
- Matching of internal pull-up / pull-down resistor expanded
- Filter time of short circuit protection test conditions improved
- Blanking time plus filter time of short circuit detection test conditions added
- Filter time for over current detection expanded
Data Sheet
37
Rev. 1.1, 2011-04-08