C161K Datasheet, PDF (37/66 Pages) Infineon Technologies AG – 16-Bit Single-Chip Microcontroller

C161K
C161O
DC Characteristics (Reduced Supply Voltage Range) (cont’d)
(Operating Conditions apply)¹⁾
Parameter
Symbol Limit Values Unit Test Condition
min. max.
PORT0 configuration current⁷⁾ I_P0H5) –
-5
I_P0L6)
-100
–
µA V_IN = V_IHmin
µA V_IN = V_ILmax
XTAL1 input current
Pin capacitance⁸⁾
(digital inputs/outputs)
I_IL CC –
C_IO CC –
±20
µA 0 V < V_IN < V_DD
10
pF f = 1 MHz
T_A = 25 °C
1) _{Keeping signal levels within the levels specified in this table, ensures operation without overload conditions.}
For signal levels outside these specifications also refer to the specification of the overload current I_OV.
2) _{Valid in bidirectional reset mode only.}
3) _{This specification is not valid for outputs which are switched to open drain mode. In this case the respective}
output will float and the voltage results from the external circuitry.
4) _{These parameters describe the RSTIN pullup, which equals a resistance of ca. 50 to 250 kΩ.}
5) _{The maximum current may be drawn while the respective signal line remains inactive.}
6) _{The minimum current must be drawn in order to drive the respective signal line active.}
7) _{This specification is valid during Reset and during Adapt-mode.}
8) _{Not 100% tested, guaranteed by design and characterization.}
Data Sheet
33
V2.0, 2001-01