1ED020I12-F Datasheet, PDF (14/22 Pages) Infineon Technologies AG – Single IGBT Driver IC

EICEDRIVER^TM
1ED020I12-F
Electrical Parameters
4.4.5
Short Circuit Clamping
Parameter
Clamping voltage (OUT)
(V_OUT-V_VCC2)
Clamping voltage (CLAMP)
(V_VCLAMP-V_VCC2)
Clamping voltage (CLAMP)
Symbol
V_CLPout
V_CLPclamp
V_CLPclamp
Limit Values
min. typ.

0.8
max.
1.3

1.3


0.7
1.1
Unit Test Conditions
V IN+=High, IN-=Low,
OUT=High
I_OUT = 500mA (pulse
test,t_CLPmax=10us)
V IN+=High, IN-=Low,
OUT=High
I_CLAMP = 500mA (pulse
test,t_CLPmax=10us)
V IN+=High, IN-=Low,
OUT=High
I_CLAMP = 20mA
4.4.6
Dynamic Characteristics
Parameter
Input to output propagation delay ON
Input to output propagation delay OFF
Input to output propagation delay
distortion
Input to output propagation delay ON
variation due to temp ²⁾
Input to output propagation delay OFF
variation due to temp ²⁾
Input to output propagation delay
distortion variation due to temp ²⁾
Rise Time
Fall Time
Symbol
T_PDON
T_PDOFF
T_PDISTO
T_PDONt
T_PDOFFt
T_PDISTOt
T_RISE
T_FALL
Limit Values
Unit Test Conditions
min.
165
150
—
typ.
185
170
20
max.
750¹⁾
190
555 ¹⁾
ns V_VCC1 = 5V,
ns ^{VVCC2 =15V,VVEE2 =-8V}
ns
C_LOAD= 100pF
V_IN+=50%, V_OUT=50%
@ 25°C
—
—
20 ns
V_VCC2 =15V,V_VEE2 =-8V
—
—
35
ns C_LOAD= 100pF
V_IN+=50%, V_OUT=50%
—
—
20 ns
—
60
—
ns V_VCC2 =15V,V_VEE2 =-8V
C_LOAD= 1nF
VL 10% ,VH 90%
—
400
—
ns V_VCC2 =15V,V_VEE2 =-8V
C_LOAD= 34nF
VL 10% ,VH 90%
—
60
—
ns V_VCC2 =15V,V_VEE2 =-8V
C_LOAD= 1nF
VL 10% ,VH 90%
—
600
—
ns V_VCC2 =15V,V_VEE2 =-8V
C_LOAD= 34nF
VL 10% ,VH 90%
1) The maximum value of input to output propagation delay ON occures only in case of electromagnetic interferences, typically the input
to output delay is 205ns at TA =25°C, one worst case watchdog clock cycle shorter (see chapter 2.2.3). The turn OFF-signal is
prioritized/dominant and will not show up this behavior.
2) The parameter is not subject to production test - verified by design/characterization
Datasheet
14
Version 2.2, 2009-12-03