1ED020I12-F Datasheet, PDF (10/22 Pages) Infineon Technologies AG – Single IGBT Driver IC

EICEDRIVER^TM
1ED020I12-F
Electrical Parameters
4
Electrical Parameters
4.1
Absolute Maximum Ratings
Note: Absolute maximum ratings are defined as ratings, which when being exceeded may lead to destruction of the integrated
circuit. Unless otherwise noted all parameters refer to GND1.
Parameter
Positive power supply output side
Negative power supply output side
Maximum power supply voltage output side
(V_VCC2-V_VEE2)
Gate driver output
Gate driver high output maximum current
Gate driver low output maximum current
Maximum short circuit clamping time
Positive power supply input side
Logic input voltages
(IN+,IN-,RST)
Opendrain Logic output voltage
(FLT)
Opendrain Logic output voltage
(RDY)
Opendrain Logic output current
(FAULT)
Opendrain Logic output current
(RDY)
Pin DESAT voltage
Pin CLAMP voltage
Symbol
V_VCC2
V_VEE2
V_max2
V_OUT
I_OUT
I_OUT
t_CLP
V_VCC1
V_LogicIN
V_FLT
V_RDY
I_FLT
I_RDY
V_DESAT
V_CLAMP
Limit Values
min.
max.
-0.3
20
-12
0.3

28
Unit Remarks
V ¹⁾
V ¹⁾
V
V_VEE2-0.3 V_max2+0.3
—
2.4
—
2.4

10
-0.3
6.5
-0.3
6.5
V
A t = 2µs
A t = 2µs
us I_CLAMP/OUT =
500mA
V
V
-0.3
6.5
V
-0.3
6.5
V

10
mA

10
mA
-0.3
V_VCC2 +0.3 V ¹⁾ V_VEE2 = -8V
V_VEE2-0.3 V_VCC2+0.3 V
2)
Junction temperature
Storage temperature
Power dissipation, Input chip
Power dissipation, Output chip
Thermal resistance (Input chip active)
Thermal resistance (Output chip active)
ESD Capability
T_J
-40
T_S
-55
P_{D, IN}

P_{D, OUT}

R_THJA,IN

R_THJA,OUT

V_ESD

150
°C
150
°C
100
mW ³⁾@TA = 25°
700
mW ³⁾@TA = 25°
160 K/W @TA = 25°C
125 K/W @TA = 25°C
1
kV Human Body
Model⁴⁾
1) With respect to GND2.
2) may be exceeded during short circuit clamping
3) Output IC power dissipation is derated linearly at 10 mW/°C above 62°C. Input IC power dissipation does not require derating. See
section 8.1 for reference layouts for these thermal data. Thermal performance may change significantly with layout and heat dissipation
of components in close proximity.
4) According to EIA/JESD22-A114-B (discharging a 100pF capacitor through a 1.5kΩ series resistor).
Datasheet
10
Version 2.2, 2009-12-03