TLE7233G Datasheet, PDF (13/32 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

SPI Driver for Enhanced Relay Control
SPIDER - TLE7233G
Power Stages
6
Power Stages
The TLE7233G is a four channel low-side relay switch.
The power stages are made of N-channel vertical power MOSFET transistors.
6.1
Input Circuit
The TLE7233G has four input pins, that can be configured to be used for control of the output stages. The INn
parameter of the SPI provide the following operation modes:
• channel is in off mode without diagnosis
(if all channels are programmed to this mode, the device goes into idle mode)
• channel is switched according to signal level at input pin INx
• channel is switched on
• channel is switched off with active diagnosis
Figure 5 shows the input circuit of TLE7233G.
IN
I
IN
Figure 4
InputStage.emf
Input signal conditioning circuit on all input and limp home pins
Datasheet
13
Rev. 1.0, 2008-02-28