TLE82452-3SA_15 Datasheet, PDF (10/71 Pages) Infineon Technologies AG – 2 Channel High-Side and Low-Side Linear Solenoid Driver IC

TLE82452-3SA
General Product Characteristics
Table 1 Absolute Maximum Ratings¹⁾ (cont’d)
T_j = -40 °C to +150 °C; all voltages with respect to ground (GNDD), positive current flowing into pin
(unless otherwise specified)
Parameter
Symbol
Min.
Values
Unit Note /
Number
Typ. Max.
Test Condition
Input Current; SCK, CSN, SI,
I_IN
RESN, EN, TM, CLK
-5
–
5
mA maximum
P_4.1.20
allowable
forward and
reverse current
through the ESD
structure
Temperatures
Junction Temperature
T_j
-40 –
150 °C continuous
P_4.1.21
operation
Storage Temperature
ESD Susceptibility
T_stg
-55 –
ESD Resistivity to GND
ESD Resistivity all pins⁷⁾
V_ESD
V_ESD
-2
–
-2
–
ESD Resistivity to GND
V_ESD
-500 –
ESD Resistivity Pin 1, 18, 19, 36 V_{ESD1,18,19,36} -750 –
(corner pins)
150 °C –
2
kV
HBM⁶⁾
2
kV
HBM⁶⁾
500 V
CDM⁸⁾
750 V
CDM⁸⁾
P_4.1.22
P_4.1.23
P_4.1.24
P_4.1.25
P_4.1.26
1) Not subject to production test, specified by design.
2) Voltage must not exceed 5.5V.
3) Voltage must not exceed 45.0V.
4) VLOADx - VGNDPx and VLSUPx-VLOADx must not exceed 45.0V.
5) Compliant to short circuit requirements according to AEC-Q100-012.
6) ESD susceptibility, HBM according to EIA/JESD 22-A114B.
7) Pin VBAT vs. Pin CPC1H : +/- 1.5kV.
8) ESD susceptibility, Charged Device Model “CDM” EIA/JESD22-C101 or ESDA STM5.3.1
Notes
1. Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
2. Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are not
designed for continuous repetitive operation.
Data Sheet
-
10
Rev 1.0, 2015-03-27