TLE4998S3C Datasheet, PDF (10/36 Pages) Infineon Technologies AG – Programmable Linear Hall Sensor

3
Maximum Ratings
TLE4998S3C
Maximum Ratings
Table 2
Absolute Maximum Ratings
Parameter
Symbol Limit Values Unit Notes
min.
max.
Storage temperature
T_ST
- 40
Junction temperature
T_J
- 40
Voltage on V_DD pin with V_DD
-18
respect to ground
150
170¹⁾
18
°C
°C
V
2)
Supply current
I_DDov
-
@ overvoltage V_DD max.
Reverse supply current I_DDrev -1
@ V_DD min.
Voltage on output pin with V_OUT -1³⁾
respect to ground
15
mA
0
mA
18⁴⁾
V
Magnetic field
ESD protection
B_MAX -
V_ESD
-
unlimited T
8
kV
According HBM
JESD22-A114-B ⁵⁾
1) _{For limited time of 96 h. Depends on customer temperature lifetime cycles. Please ask for support by Infineon}
2) _{Higher voltage stress than absolute maximum rating, e.g. 150% in latch-up tests is not applicable. In such}
cases, R_series ≥100 Ω for current limitation is required
3) _{IDD can exceed 10 mA when the voltage on OUT is pulled below -1 V (-5 V at room temperature)}
4) _{VDD = 5 V, open drain permanent low, for max. 10 minutes}
5) _{100 pF and 1.5 kΩ}
Note: Stresses above those listed under “Absolute Maximum Ratings” may cause
permanent damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in
the operational sections of this specification is not implied.
Exposure to absolute maximum rating conditions for extended periods may affect
device reliability.
Data Sheet
10
Rev 1.1, 2009-09