|
ICS8S89831I Datasheet, PDF (11/21 Pages) Integrated Device Technology – Output frequency | |||
|
◁ |
ICS8S89831I Data Sheet
DIFFERENTIAL LVPECL-TO-LVPECL/ECL FANOUT BUFFER
Termination for 3.3V LVPECL Outputs
The clock layout topology shown below is a typical termination for
LVPECL outputs. The two different layouts mentioned are
recommended only as guidelines.
The differential outputs are low impedance follower outputs that
generate ECL/LVPECL compatible outputs. Therefore, terminating
resistors (DC current path to ground) or current sources must be
used for functionality. These outputs are designed to drive 50â¦
transmission lines. Matched impedance techniques should be used
to maximize operating frequency and minimize signal distortion.
Figures 4A and 4B show two different layouts which are
recommended only as guidelines. Other suitable clock layouts may
exist and it would be recommended that the board designers
simulate to guarantee compatibility across all printed circuit and clock
component process variations.
3.3V
Zo = 50â¦
3.3V
+
LVPECL
Zo = 50â¦
R1
50â¦
RTT =
1
((VOH + VOL) / (VCC â 2)) â 2
* Zo
_
Input
R2
50â¦
VCC - 2V
RTT
Figure 4A. 3.3V LVPECL Output Termination
3.3V
LVPECL
3.3V
R3
R4
125â¦
125â¦
3.3V
Zo = 50â¦
+
Zo = 50â¦
R1
84â¦
_
R2
84â¦
Input
Figure 4B. 3.3V LVPECL Output Termination
ICS8S89831AKI REVISION A APRIL 26, 2010
11
©2010 Integrated Device Technology, Inc.
|
▷ |