ICS9248-92 Datasheet, PDF (7/14 Pages) Integrated Circuit Systems – Mobile Pentium IITM System Clock Chip

ICS9248-92
Power Management
Clock Enable Configuration
CPU_STOP# PCI_STOP# PWR_DWN# CPUCLK
X
X
0
0
0
1
1
0
1
1
0
Low
1
Low
1
Low
1
100/66.6 MHz
1
100/66.6 MHz
PCICLK
Low
Low
33.3 MHz
Low
33.3 MHz
Other Clocks,
SDRAM,
REF,
48/24 MHz A
48/24 MHz B
Stopped
Running
Running
Running
Running
Crystal
Off
Running
Running
Running
Running
VCOs
Off
Running
Running
Running
Running
Full clock cycle timing is guaranteed at all times after the system has initially powered up except where noted. During power
up and power down operations using the PWR PD# select pin will not cause clocks of a short or longer pulse than that of the
running clock. The first clock pulse coming out of a stopped clock condition may be slightly distorted due to clock network
charging circuitry. Board routing and signal loading may have a large impact on the initial clock distortion also.
ICS9248-92 Power Management Requirements
SIGNAL
CPU_ STOP#
PCI_STOP#
PWR_DWN#
SIGNAL STATE
0 (Disabled)²
1 (Enabled)¹
0 (Disabled)²
1 (Enabled)¹
1 (Normal Operation)³
0 (Power Down)⁴
Latency
No. of rising edges of free running
PCICLK
1
1
1
1
3mS
2max
Notes.
1. Clock on latency is defined from when the clock enable goes active to when the first valid clock comes out of the device.
2. Clock off latency is defined from when the clock enable goes inactive to when the last clock is driven low out of the device.
3. Power up latency is when PD# goes inactive (high) to when the first valid clocks are output by the device.
4. Power down has controlled clock counts applicable to CPUCLK, SDRAM, PCICLK only.
The REF will be stopped independant of these.
7