ICS874005 Datasheet, PDF (7/12 Pages) Integrated Circuit Systems – PCI EXPRESS TM JITTER ATTENUATOR

Integrated
Circuit
Systems, Inc.
ICS874005
PCI EXPRESS™
JITTER ATTENUATOR
DIFFERENTIAL CLOCK INPUT INTERFACE
The CLK /nCLK accepts LVDS, LVPECL, LVHSTL, SSTL, HCSL
and other differential signals. Both V_SWING and V_OH must meet the
V_PP and V_CMR input requirements. Figures 3A to 3D show inter-
face examples for the HiPerClockS CLK/nCLK input driven by
the most common driver types. The input interfaces suggested
here are examples only. Please consult with the vendor of the
driver component to confirm the driver termination requirements.
For example in Figure 3A, the input termination applies for ICS
HiPerClockS LVHSTL drivers. If you are using an LVHSTL driver
from another vendor, use their termination recommendation.
1.8V
Zo = 50 Ohm
Zo = 50 Ohm
LVHSTL
ICS
HiPerClockS
LVHSTL Driver
3.3V
CLK
nCLK _HiPerClockS
Input
R1
R2
50
50
3.3V
Zo = 50 Ohm
LVPECL
Zo = 50 Ohm
3.3V
CLK
nCLK _HiPerClockS
Input
R1
R2
50
50
R3
50
FIGURE 3A. HIPERCLOCKS CLK/NCLK INPUT DRIVEN BY
ICS HIPERCLOCKS LVHSTL DRIVER
FIGURE 3B. HIPERCLOCKS CLK/NCLK INPUT DRIVEN BY
3.3V LVPECL DRIVER
3.3V
Zo = 50 Ohm
LVPECL
Zo = 50 Ohm
3.3V
R3
R4
125
125
3.3V
CLK
nCLK _HiPerClockS
Input
R1
R2
84
84
3.3V
Zo = 50 Ohm
LVDS_Driv er
R1
100
Zo = 50 Ohm
3.3V
CLK
nCLK _{Receiv er}
FIGURE 3C. HIPERCLOCKS CLK/NCLK INPUT DRIVEN BY
3.3V LVPECL DRIVER
FIGURE 3D. HIPERCLOCKS CLK/NCLK INPUT DRIVEN BY
3.3V LVDS DRIVER
RECOMMENDATIONS FOR UNUSED INPUT AND OUTPUT PINS
INPUTS:
OUTPUTS:
LVCMOS CONTROL PINS:
All control pins have internal pull-ups or pull-downs; additional
resistance is not required but can be added for additional
protection. A 1kΩ resistor can be used.
LVDS
All unused LVDS output pairs can be either left floating or
terminated with 100Ω across. If they are left floating, we
recommend that there is no trace attached.
874005AG
www.icst.com/products/hiperclocks.html
7
REV. A JANUARY 25, 2006