English
Language : 

HMS87C13042A Datasheet, PDF (57/88 Pages) Hynix Semiconductor – 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS87C130XA/120XA/110XA
15. INTERRUPTS
The HMS87C1X0XA interrupt circuits consist of Interrupt
enable register (IENH, IENL), Interrupt request flags of
IRQH, IRQL, Interrupt Edge Selection Register (IEDS),
priority circuit and Master enable flag(“I” flag of PSW).
The configuration of interrupt circuit is shown in Figure
15-1and Interrupt priority is shown in Table 15-1.
The External Interrupts INT0 and INT1 can each be transi-
tion-activated (1-to-0, 0-to-1 and both transition).
The flags that actually generate these interrupts are bit
INT0IF and INT1IF in Register IRQH. When an external
interrupt is generated, the flag that generated it is cleared
by the hardware when the service routine is vectored to
only if the interrupt was transition-activated.
The Timer 0 and Timer 1 Interrupts are generated by T0IF
and T1IF, which are set by a match in their respective tim-
er/counter register. The AD converter Interrupt is generat-
ed by ADIF which is set by finishing the analog to digital
conversion. The Watch dog timer Interrupt is generated by
WDTIF which set by a match in Watch dog timer register
(when the bit WDTON is set to “0”). The Basic Interval
Timer Interrupt is generated by BITIF which is set by a
overflowing of the Basic Interval Timer Register(BITR).
External Int. 0
External Int. 1
IEDS
Timer 0
Timer 1
A/D Converter
WDT
BIT
Internal bus line
IRQH
7
INT0IF
INT1IF 6
T0IF 5
T1IF 4
ADIF 7
6
WDTIF
5
BITIF
IENH
Interrupt Enable
Register (Higher byte)
I-flag is in PSW, it is cleared by “DI”, set by
“EI” instruction.When it goes interrupt service,
I-flag is cleared by hardware, thus any other
interrupt are inhibited. When interrupt service is
completed by “RETI” instruction, I-flag is set to
“1” by hardware.
Release STOP
I Flag
Interrupt Master
Enable Flag
Interrupt
Vector
Address
Generator
To CPU
IRQL
IENL
Interrupt Enable
Register (Lower byte)
Internal bus line
Figure 15-1 Block Diagram of Interrupt Function
54
Apr. 2001 ver 1.0