HCPL-7100 Datasheet, PDF (8/14 Pages) Agilent(Hewlett-Packard) – High Speed CMOS Optocouplers

Switching Specifications (cont.)
Guaranteed across recommended operating conditions. Test conditions represent worst case values for the
parameter under test. Test conditions that are not specified can be anywhere within their operating range. All
typicals are at 25°C and 5 V supplies unless otherwise noted.
Parameter
Propagation
Delay Time from
Logic High to
Output Disabled
Symbol
t_PHZ
Device
Min. Typ.
12
12
Max.
Unit
ns
ns
Test Conditions
C_L = 50 pF
CMOS Signal Levels
C_L = 15 pF
TTL Signal Levels
Fig. Note
12 6
Propagation
t_PLZ
9
Delay Time from
Logic Low to
Output Disabled
11
Common Mode
Transient
Immunity at
Logic High
Output
Common Mode
Transient
Immunity at
Logic Low
Output
|CM_H| HCPL-7100 1000
HCPL-7101 2000
|CM_L|
HCPL-7100 1000
HCPL-7101 2000
Input Dynamic
C_PD1
68
Power Dissipation
Capacitance
Output Dynamic
C_PD2
10
Power Dissipation
Capacitance
ns C_L = 50 pF
CMOS Signal Levels
12 6
ns C_L = 15 pF
TTL Signal Levels
V/µs V_CM = 50 V V_I = V_IH
13, 10
V_D > 3.2 V 14
V_CM = 200 V
V/µs V_CM = 50 V V_I = V_IL
13, 10
V_D < 0.8 V 14
V_CM = 200 V
pF
11
pF
11
Package Characteristics
Guaranteed across recommended operating conditions. Test conditions represent worst case value for the
parameter under test. Test conditions that are not specified can be anywhere within their operating range.
All typicals are at T_A = 25°C and 5 V supplies unless otherwise noted.
Parameter
Sym. Min. Typ. Max. Units
Test Conditions
Fig. Note
Input-Output
Momentary
V_ISO 3750
Withstand Voltage*
V rms t = 1 min., RH < 50%,
2, 3
T_A = 25°C
Input-Output
Resistance
Input-Output
Capacitance
R_I-O 10¹² 10¹³
10¹¹
C_I-O
0.7
Ω
T_A = 25°C V_I-O = 500 Vdc
2
T_A =100°C
pF f = 1 MHz
2
*The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output
continuous voltage rating. For the continuous voltage rating refer to the VDE 0884 Insulation Characteristics Table (if applicable),
your equipment level safety specification or HP Application Note 1074 entitled “Optocoupler Input-Output Endurance Voltage.”
1-409