HFBR-59L1AL Datasheet, PDF (15/16 Pages) Agilent(Hewlett-Packard) – Agilent HFBR-59L1AL 1.25 GBd Ethernet and 1.0625 GBd Fibre Channel 850 nm SFF Low Voltage (3.3 V) Optical Transceiver

∅0.00 M A
20x ∅_{(00.0.8312±±00..10004)}
∅0.00 M A
4x ∅_{(01.0.4505±±00..10004)(NOTE} 5)
25.75
(1.014)
SEE NOTE 3
SEE DET AIL A
13.34
(0.525)
12.16
(0.479)
54321
678910
(105.6.2040)MINIMUM ^PITCH
7.59 10.16
(0.299) (0.400)
SEE DETAIL B
3.56
(0.140)
4.57 (0.180)
7.11 (0.280)
8.89 (0.350)
9x(01..07780)
2x ∅_{(02..02990)MAX.(AREA} FOR EYELETS)
2x ∅_{(01.0.4505±±00..10004)(NOTE} 4)
∅0.00 M A
3.00
(0.118)
6.00
(0.236)
3.00
(0.118)
DETAIL A (3x)
1.80
(0.071)
1.00
(0.039)
DETAIL B (4x)
1.00
+1.50
–0
(0.039 ^{+–00..000509)}
(105.6.2040)MIN.PITCH
A
A
(0.14272)REF. ^MAX.
15.75
+0
–0.75
A
(0.620 ^{+–00..003000)}
14.22 ±0.10
(0.560 ±0.004)
10.16 ±0.10
(0.400 ±0.004)
TOP OF PCB
SECTION A-A
Notes:
1. This page describes the recommended circuit board layout and front panel openings for SFF transceivers.
2. The hatched areas are keep-out areas reserved for housing standoffs. No metal traces allowed in keep-out areas..
3. The drawing shows extra pin holes for 2x10 pin transceivers. These extra holes are not required for HFBR-59L1AL.
4. Holes for mounting studs must be tied to chassis ground.
5. Holes for housing leads mst be tied to signal ground.
6. Dimensions are in millimeters (inches).
Figure 6b. Recommended SFF host board and front panel layout.
14