HCPL-J314 Datasheet, PDF (15/17 Pages) Agilent(Hewlett-Packard) – 0.4 Amp Output Current IGBT Gate Drive Optocoupler

15
CMR with the LED On
(CMR_H)
A high CMR LED drive circuit
must keep the LED on during
common mode transients. This is
achieved by overdriving the LED
current beyond the input
threshold so that it is not pulled
below the threshold during a
transient. A minimum LED
current of 8 mA provides
adequate margin over the
maximum I_FLH of 5 mA to
achieve 10 kV/µs CMR.
CMR with the LED Off
(CMR_L)
A high CMR LED drive
circuit must keep the LED off
(V_F ≤ V_F(OFF)) during common
mode transients. For example,
during a -dV_CM/dt transient in
Figure 23, the current flowing
through C_LEDP also flows
through the R_SAT and V_SAT of the
logic gate. As long as the low
state voltage developed across
the logic gate is less than V_F(OFF)
the LED will remain off and no
common mode failure will occur.
The open collector drive circuit,
shown in Figure 24, can not keep
the LED off during a +dV_CM/dt
transient, since all the current
flowing through C_LEDN must be
supplied by the LED, and it is
not recommended for
applications requiring ultra high
CMR₁ performance. The
alternative drive circuit which
like the recommended
application circuit (Figure 19),
does achieve ultra high CMR
performance by shunting the
LED in the off state.
IPM Dead Time and
Propagation Delay
Specifications
The HCPL-J314 includes a
Propagation Delay Difference
(PDD) specification intended to
help designers minimize “dead
time” in their power inverter
designs. Dead time is the time
high and low side power
transistors are off. Any overlap
in Ql and Q2 conduction will
result in large currents flowing
through the power devices from
the high-voltage to the low-
voltage motor rails. To minimize
dead time in a given design, the
turn on of LED2 should be
delayed (relative to the turn off
of LED1) so that under worst-
case conditions, transistor Q1
has just turned off when
transistor Q2 turns on, as shown
in Figure 26. The amount of
delay necessary to achieve this
condition is equal to the
maximum value of the
propagation delay difference
specification, PDD max, which is
specified to be 500 ns over the
operating temperature range of
-40° to 100°C.
Delaying the LED signal by the
maximum propagation delay
difference ensures that the
minimum dead time is zero, but it
does not tell a designer what the
maximum dead time will be. The
maximum dead time is equivalent
to the difference between the
maximum and minimum
propagation delay difference
specification as shown in
Figure 27. The maximum dead
time for the HCPL-J314 is 1 µs
(= 0.5 µs - (-0.5 µs)) over the
operating temperature range of
-40°C to 100°C.
Note that the propagation delays
used to calculate PDD and dead
time are taken at equal
temperatures and test conditions
since the optocouplers under
consideration are typically
mounted in close proximity to
each other and are switching
identical IGBTs.