BH66F2260 Datasheet, PDF (15/214 Pages) Holtek Semiconductor Inc – R-Sensor Blood Pressure Meter Flash MCU

BH66F2260
R-Sensor Blood Pressure Meter Flash MCU
Standby Current Characteristics
Ta=25°C
Symbol
Standby Mode
SLEEP Mode
IDLE0 Mode
IDLE1 Mode – HIRC
ISTB
IDLE1 Mode – HXT
VDD
2.2V
3V
5V
2.2V
3V
5V
2.2V
3V
5V
2.2V
3V
5V
2.2V
3V
5V
2.7V
3V
5V
2.2V
3V
5V
2.2V
3V
5V
2.7V
3V
5V
3.3V
5V
Test Conditions
Conditions
WDT off
WDT on
fSUB on
fSUB on, fSYS=4MHz
fSUB on, fSYS=8MHz
fSUB on, fSYS=12MHz
fSUB on, fSYS=4MHz
fSUB on, fSYS=8MHz
fSUB on, fSYS=12MHz
fSUB on, fSYS=16MHz
Max.
Min. Typ. Max. _85°C Unit
— TBD TBD TBD
— 0.2 0.8 TBD μA
— 0.5 1 TBD
— TBD TBD TBD
— 1.5 3 TBD μA
—3
5 TBD
— TBD TBD TBD
—3
5 TBD μA
— 5 10 TBD
— TBD TBD TBD
— 0.25 0.36 TBD mA
— 0.45 0.72 TBD
— TBD TBD TBD
— 0.42 0.6 TBD mA
— 0.8 1.2 TBD
— TBD TBD TBD
— 0.6 0.9 TBD mA
— 1.2 1.8 TBD
— TBD TBD TBD
— 0.25 0.36 TBD mA
— 0.45 0.72 TBD
— TBD TBD TBD
— 0.42 0.6 TBD mA
— 0.8 1.2 TBD
— TBD TBD TBD
— 0.6 0.9 TBD mA
— 1.2 1.8 TBD
— TBD TBD TBD
mA
— 1.8 2.4 TBD
Notes: When using the characteristic table data, the following notes should be taken into consideration:
• Any digital inputs are setup in a non-floating condition.
• All measurements are taken under conditions of no load and with all peripherals in an off state.
• There are no DC current paths.
• All Standby Current values are taken after a HALT instruction execution thus stopping all instruction
execution.
Rev. 1.00
15
March 15, 2017