HMC686LP4 Datasheet, PDF (12/18 Pages) Hittite Microwave Corporation – BiCMOS MIXER W/ INTEGRATED LO AMPLIFIER, 700 - 1500 MHz

v05.0509
HMC686LP4 / 686LP4E
BiCMOS MIXER W/ INTEGRATED
LO AMPLIFIER, 700 - 1500 MHz
Pin Descriptions
Pin Number
1, 6, 7, 11 - 14,
18, 20, 23
Function
N/C
2, 5, 15, 17
GND
3
RF
4
TAP
Description
No connection. These pins may be connected to RF
ground. Performance will not be affected.
Package bottom must be
connected to RF/DC ground.
This pin is matched single-ended to 50 Ohms and DC
shorted to ground through a balun.
Center tap of secondary side of the internal RF balun.
Short to ground with zero ohms close to the package.
Interface Schematic
10
8, 10, 24
Vcc1, Vcc2,
Vcc3
Power supply voltage. See application circuit
for required external components.
LO buffer current adjustment pin. Adjust the LO buffer
current through the external resistor R9 shown in the
9
LO_BIAS
application circuit (connect 330 Ohms for nominal
operation). This adjustment allows for a trade-off
between power dissipation and linearity performance of
the converter.
16
LO
This pin is matched single-ended to 50 Ohms and DC
shorted to ground through a balun.
External bias. See application circuit for recom-
mended external components. Apply +3.5V for nominal
operation at 5V supply voltage. G_Bias can be set to
19
G_BIAS
between 0 and 5Vdc. The G_bias pin has an internal
15K ohm resistance to ground. This adjustment allows
for a trade off between conversion loss and linearity
performance of the converter (see figures CG, IP3 vs.
G-Bias).
21, 22
IFN, IFP
Differential IF input / output pins matched to differential
50 Ohms. For applications not requiring operation to
DC an off chip DC blocking capacitor should be used.
For price, delivery and to place orders: Hittite Microwave Corporation, 20 Alpha Road, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
Application Support: Phone: [phone] or [e-mail]
10 - 12