IC11S-68PL-1.27SF-EJR Datasheet, PDF (22/38 Pages) Hirose Electric – Single Slot SMT Connectors For Card-Bus Based PC Cards

sPreCautions In Installation To Boards
1. After installation of SMT unit to boards, verify that the stroke arm of SMT unit
and the push rod of guide unit are located on the positions shown in fig._➀.
Also note that guide unit cannot be solder reflowed.
Pict.➀
Guide unit
SMT unit
Push rod
Stroke arm
2. Note that the stroke arm of SMT unit and the push rod of guide unit cannot be combined when
located in the position as shown in fig.➁.
Pict.➁
Guide unit
SMT unit
If located in the position shown in fig.➁ move it to the position shown in fig. ➀ by fingers.
Guide unit
SMT unit
3. After SMT unit and guide unit are combined, state will be found as follows :
qWhen the push rod was pressed:
qWhen the push rod was extracted:
intervention
intervention
A23