IC11S-68PL-1.27SF-EJR Datasheet, PDF (20/38 Pages) Hirose Electric – Single Slot SMT Connectors For Card-Bus Based PC Cards

sHow To Install In Board(Standard Type)
(1)Install SMT unit.
(2)Position the lock section of guide unit into the hole of SMT unit.
(3)Press the lock top of guide unit to push into SMT unit securely (i.e., until clicked.)
(Note.) Avoid pressing any section other than lock top because it may cause guide plate deformation.
(4)Screw 2 spots to guide unit from the back side of board.
Screw designation
M2
Pitch
0.4
Recommended tightening torque
1.5 to 2.0 (kgf • cm)
A21