FH33-28S-0.5SH Datasheet, PDF (13/16 Pages) Hirose Electric – 0.4mm,0.5mm,1mm Pitch, 1.2mm above the board, Flexible Printed Circuit & Flexible Flat Cable ZIF Connectors

FH33 Seriesq0.4mm,0.5mm,1mm Pitch, 1.2mm above the board, Flexible Printed Circuit & Flexible Flat Cable ZIF Connectors
Precautions
4 When operating the actuator, do so at the
center portion.
5 As illustrated, do not attempt removal or re-
positioning of the actuator.
S FPC Insertionq
The FPC should be aligned parallel with the board surface and perpendicular with the connector (as shown),
then completely inserted.
Actuator
Perpendicular with
the connector
FPC
To assure correct electrical and mechanical connection do not insert FPC at angle. It must be fully inserted.
Make sure that the FPC is NOT MOVED during the closing of the actuator.
SFPC Insertionw
When inserting the FPC, do not forcefully rub against the bottom surface of the connector insertion entrance.
Doing so will result in the contacts and FPC making strong contact and may cause deformation of the
contacts, peeling of the FPC conductor, and other problems.
Peeling of FPC
conductor
13