HR30-6PA-6SC_1 Datasheet, PDF (11/12 Pages) Hirose Electric – Miniature Waterproof Plastic Connectors

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
Cable
Push/pull
locking collar
A
Plug insulator body
Cable
Back shell
Guide keys
View A (2:1)
Cable
Tightening collar for back shell
Solder termination fixture
3
Groove - sealing bushing
Front edge of cable jacket
Figure B
Figure C
Connector
3 and 6 Pos.
10 and 12 Pos.
Back shell tightening collar size
16 mm
18 mm
Torque
0.5N.m
0.5N.m
1. To prevent accidental loosening of the back shell it is recommended that a small amount of primer (Loctite® 7649) and
adhesive (Loctite® 271) be applied to the threads of the insulator body before proceeding.
2. Keeping the terminated insulator body on the fixture, re-assembly the plug in order shown.
4. Using the correct back-tightening collar tighten the back shell to the specified torque.
When tightening the collar make sure that the cable will NOT turn.
5. Remove the assembly from the fixture.
Note: Loctite is a registered trademark of the Henkel Loctite Corporation.
11