S8980_S10810_15 Datasheet, PDF (3/10 Pages) Hamamatsu Corporation – CCD area image sensors

CCD area image sensors
S8980, S10810-11
Electrical and optical characteristics (Ta=25 °C, VOD=15 V, unless otherwise noted)
Parameter
Symbol
Min.
Vertical
100
Full well capacity
Horizontal
Fw
-
Summing
-
CCD node sensitivity*⁵
Sv
1.0
Dark current (MPP mode)*⁶
DS
-
Readout noise*⁷
Ta=25 °C
Nr
-
Ta=-40 °C
-
Dynamic range*⁸
DR
-
X-ray response non-uniformity*⁹ *¹⁰
XRNU
-
Point
White spots
-
Blemish*¹¹
defects*¹² Black spots
Cluster defects*¹³
-
-
-
Column defects*¹⁴
-
X-ray resolution*⁹
∆R
15
Typ.
200
300
600
1.4
250
90
60
3333
±10
-
-
-
-
20
Max.
-
-
-
-
2500
-
-
-
±30
20
20
3
1
-
*5: VOD=15 V, RL (load resistor of emitter follower)=1 kΩ
*6: Dark signal doubles for every 5 to 7 °C.
*7: Operating frequency is 1 MHz.
*8: Dynamic range = Full well capacity / Readout noise
*9: X-ray irradiation of 60 kVp, measured at half of the full well capacity
*10: XRNU (%) = Noise / Signal × 100
Noise: Fixed pattern noise (peak to peak)
In the range that excludes 5 pixels from edges to the center at every position
*11: Refer to “Characteristics and use of FFT-CCD area image sensor” of technical information.
*12: White spots > 10 times of Max. Dark signal (2500 e^-/pixel/s)
Black spots > 50% reduction in response relative to adjacent pixels, measured at half of the full well capacity
*13: Continuous 2 to 9 point defects
*14: Continuous ≥ 10 point defects
Unit
ke^-
μV/e^-
e^-/pixel/s
e^- rms
-
%
-
Lp/mm
Resolution (S10810-11)
(X-ray source: 70 kVp, Filter: ABS 1.5 mm^t)
1.0
0.9
0.8
0.7
0.6
0.5
0.4
0.3
0.2
0.1
0
0 2 4 6 8 10 12 14 16 18 20
Spatial frequency (line pairs/mm)
KMPDB0355EA
Response (S10810-11)
(X-ray source: 70 kVp, Filter: ABS 1.5 mm^t)
300
200
100
0
0
100
200
300
Absorbed dose (µGy)
KMPDB0356EA
3