UMFT240XE Datasheet, PDF(15/18 Page) Future Technology Devices International Ltd. – UMFT240XE USB to 8-bit 245 FIFO Development Module

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

UMFT240XE Datasheet, PDF (15/18 Pages) Future Technology Devices International Ltd. – UMFT240XE USB to 8-bit 245 FIFO Development Module

◁

UMFT240XE

Version 1.0

Document Reference No.: FT_000653 Clearance No.: FTDI# 295

8 Internal MTP ROM Configuration

Following a power-on reset or a USB reset the FT240X will scan its internal MTP ROM and read the USB

configuration descriptors stored there. The default values programmed into the internal MTP ROM in the

FT240XQ used on the UMFT240XE are shown in Table 8.1.

Parameter

Value

Notes

USB Vendor ID (VID)

0403h

FTDI default VID (hex)

USB Product UD (PID)

6015h

FTDI default PID (hex)

Serial Number Enabled?

Yes

Serial Number

See Note

A unique serial number is generated and programmed into

the MTP ROM during final test of the UM232R module.

Pull down I/O Pins in USB

Suspend

Disabled

Enabling this option will make the device pull down on the

UART interface lines when the power is shut off (PWREN#

is high).

Manufacturer Name

FTDI

Product Description

UMFT240XE

Max Bus Power Current

90mA

Power Source

Bus Powered

Device Type

FT240X

USB Version

0200

Returns USB 2.0 device description to the host. Note: The

device is a USB 2.0 Full Speed device (12Mb/s) as opposed

to a USB 2.0 High Speed device (480Mb/s).

Remote Wake Up

Enabled

Taking RI# low will wake up the USB host controller from

suspend.

High Current I/Os

Disabled

Enables the high drive level on the data and CBUS I/O pins.

Load VCP Driver

Enabled

Makes the device load the CVP driver interface for the

device.

CBUS5

Tristate

CBUS6

Tristate

Table 8.1 â Default Internal MTP ROM Configuration

The internal MTP ROM in the FT240X can be programmed over USB using the utility program FT_PROG.

FT_PROG can be downloaded from the www.ftdichip.com. Users who do not have their own USB vendor

ID but who would like to use a unique Product ID in their design can apply to FTDI for a free block of

unique PIDs. Contact FTDI Support (support1@ftdichip.com) for this service, also see TN_100 and

TN_101.

▷