English
Language : 

MC33580 Datasheet, PDF (11/38 Pages) Freescale Semiconductor, Inc – Quad High-Side Switch (Quad 15 mΩ)
ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
Table 4. Dynamic Electrical Characteristics (continued)
Characteristics noted under conditions 6.0 V ≤ VPWR ≤ 27 V, 4.5 V ≤ VDD ≤ 5.5 V, - 40°C ≤ TA ≤ 125°C, GND = 0 V unless
otherwise noted. Typical values noted reflect the approximate parameter means at TA = 25°C under nominal conditions unless
otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
POWER OUTPUT TIMING (HS0, HS1, HS2, HS3) (continued)
Output Turn-ON Delay Time in Slow Slew Rate (21)
DICR = 0
Output Turn-ON Delay Time in Fast Slew Rate (21)
DICR = 1
Output Turn-OFF Delay Time in Slow Slew Rate Mode (22)
DICR = 0
Output Turn-OFF Delay Time in Fast Slew Rate Mode (22)
DICR = 1
t DLY_SLOW(ON)
µs
2.0
10
130
t DLY_FAST(ON)
µs
1.0
3.0
60
t DLY_SLOW(OFF)
µs
20
100
400
t DLY_FAST(OFF)
µs
5.0
20
100
Overcurrent Low Detection Blanking Time
OCLT[1:0] : 00
OCLT[1:0] : 01 (23)
OCLT[1:0] : 10
OCLT[1:0] : 11
t OCL0
t OCL1
t OCL2
t OCL3
ms
108
155
202
–
–
–
55
75
95
0.08
0.15
0.3
Overcurrent High Detection Blanking Time
CS to CSNS Valid Time (24)
Watchdog Timeout (25)
WD[1:0] : 00
WD[1:0] : 01
WD[1:0] : 10
WD[1:0] : 11
tOCH
1.0
5
20
µs
t CNSVAL
–
–
10
µs
ms
t WDTO0
t WDTO1
t WDTO2
t WDTO3
446
223
1800
900
558
279
2250
1125
725
363
2925
1463
Notes
21. Turn-ON delay time measured from rising edge of any signal (IN[0:3], SCLK, CS) that would turn the output ON to VHS[0:3] = 0.5 V with
RL = 5.0 Ω resistive load.
22. Turn-OFF delay time measured from falling edge of any signal (IN[0:3], SCLK, CS) that would turn the output OFF to VHS[0:3] = VPWR-
0.5 V with RL = 5.0 Ω resistive load.
23. This logical bit is not defined. Do not use.
24. Time necessary for the CSNS to be with ±5% of the targeted value.
25. Watchdog timeout delay measured from the rising edge of WAKE or RST from a sleep state condition, to output turn-ON with the output
driven OFF and FSI floating. The values shown are for WDR setting of [00]. The accuracy of t WDTO is consistent for all configured
watchdog time-outs.
Analog Integrated Circuit Device Data
Freescale Semiconductor
33580
11