S9S08SC4E0MTG Datasheet, PDF (1/31 Pages) Freescale Semiconductor, Inc – MC9S08SC4 8-Bit Microcontroller Data Sheet

Freescale Semiconductor
Data Sheet: Technical Data
MC9S08SC4 8-Bit
Microcontroller Data Sheet
Document Number: MC9S08SC4
Rev. 4, 6/2010
MC9S08SC4
948F-01
8-Bit HCS08 Central Processor Unit (CPU)
• Up to 40 MHz HCS08 CPU (central processor unit); up
to 20 MHz bus frequency
• HC08 instruction set with added BGND instruction
On-Chip Memory
• 4 KB of FLASH with read/program/erase over full
operating voltage and temperature
• 256 bytes of Random-access memory (RAM)
Power-Saving Modes
• Two very low power stop modes
• Reduced power wait mode
Clock Source Options
• Oscillator (XOSC) — Loop-control Pierce oscillator;
Crystal or ceramic resonator range of 32 kHz to 38.4 kHz
or 1 MHz to 16 MHz
• Internal Clock Source (ICS) — Internal clock source
module containing a frequency-locked loop (FLL)
controlled by internal or external reference; precision
trimming of internal reference allows 0.2 % resolution
and 2.0 % deviation over temperature and voltage;
supports bus frequencies from 2 MHz to 20 MHz.
System Protection
• Watchdog computer operating properly (COP) reset with
option to run from dedicated 1 kHz internal clock source
or bus clock
• Low-voltage detection with reset or interrupt; selectable
trip points
• Illegal opcode detection with reset
• Illegal address detection with reset
• FLASH block protect
• Reset on loss of clock
Development Support
• Single-wire background debug interface
• Breakpoint capability to allow single breakpoint setting
during in-circuit debugging
Peripherals
• SCI — Serial Communication Interface
— Full-duplex non-return to zero (NRZ)
— LIN master extended break generation
— LIN slave extended break detection
— Wake-up on active edge
• TPMx — Two 2-channel Timer/PWM modules (TPM1
and TPM2)
— 16-bit modulus or up/down counters
— Input capture, output compare, buffered
edge-aligned or center-aligned PWM
• ADC — Analog to Digital Converter
— 8-channel, 10-bit resolution
— 2.5 μs conversion time
— Automatic compare function
— Temperature sensor
— Internal bandgap reference channel
Input/Output
• 12 general purpose I/O pins (GPIOs)
• 8 interrupt pins with selectable polarity
• Hysteresis and configurable pull-up device on all input
pins; Configurable slew rate and drive strength on all
output pins.
Package Options
• 16-TSSOP
Operating Parameters
• 4.5-5.5 V operation
• C,V, M temperature ranges available, covering -40 -
125 °C operation
Freescale reserves the right to change the detail specifications as may be required to permit
improvements in the design of its products.
© Freescale Semiconductor, Inc., 2009-2010. All rights reserved.