English
Language : 

XRT8000_06 Datasheet, PDF (5/24 Pages) Exar Corporation – Clock Synchronizer/Adapter for Communications
XRT8000
DC ELECTRICAL CHARACTERISTICS (Except Serial Interface) Operating Temperature: -40_C to 85_C
Test Conditions: TA = 25_C, VCC = 3.3V ± 5% Unless Otherwise Specified
Symbol
Parameter
Min Typ Max Unit
Conditions
VIL
Input low level
VIH Input high level
VOL Output low level (CLK1,CLK2)
VOH Output high level (CLK1,CLK2)
VOL Output low level (LOCKDET,SYNC)
VOH Output high level (LOCKDET,SYNC)
IIL
Input low current (CSB,MSB)
IIH
Input high current (CSB,MSB)
IIL
Input low current (except CSB,MSB)
IIH
Input high current (except CSB,MSB)
ICC Operating current
RIN Input pull-up resistance (CSB,MSB)
0.8
2.0
0.4
2.4
0.4
2.4
-150
10
-10
10
11
30
50 100 150
V
V
V IOL = -3 mA
V IOH = 3 mA
V IOL = -2.5 mA
V IOH = 2.5 mA
mA
mA VIN = VCC
mA
mA VIN = VCC
mA No load. Clock = 2.1 MHz
KW
AC ELECTRICAL CHARACTERISTICS (See Figure 3)
Symbol
Parameter
Spec.3 Min Typ Max
T1
Input frequency
T2
Minimum input signal high to
low duration
0.008
32.7
12
T3
Output frequency
T61
Duty cycle CLK1, CLK2
1.2
2.1
47.5 50
52.5
T74
Jitter added 8KHz-40KHz
T74
Jitter added 10Hz-40KHz
T74
Broad Band
T74
Jitter added 20Hz-100KHz
T74
Jitter added 18kHz-100KHz
T8
Capture time
T9
Clock output rise time
0.025
0.025
0.05
1.5
0.2
0.01 0.02
0.030
0.035 0.05
0.045 0.07
0.010 0.03
40
14
T10
Clock output fall time
14
T112
Duty cycle SYNC
40
60
T14
Delay time between SYNC
and CLK1 or CLK2
T-20
T
T+20
Unit
MHz
ns
Conditions
KHz
% VCC/2 switch point. 30pF
load.
UI Output =1.544MHz
UI Output =1.544MHz
UI Output =1.544MHz
UI Output =2.048MHz
UI Output =2.048MHz
ms
ns 30pF load. Measured at
20/80 %
ns 30pF load. Measured at
20/80 %
% VCC/2 switch point
(in master forward mode).
30pF load.
ns See table 12 for values of T
Notes:
T4
1 T6 = ( T 4 + T 5 )
T 12
2 T11 = ( T 12 + T 13 )
3 Specifications from AT&T Publication 62411 and ITUT Rcommendations G-823 (for 1.544MHz and 2.048MHz, respectively)
4 T7 is guaranteed by characterization, not tested.
Specifications are subject to change without notice.
Rev. 1.11
5