XR16L2551 Datasheet, PDF (35/48 Pages) Exar Corporation – LOW VOLTAGE DUART WITH POWERSAVE

áç
REV. 1.0.0
XR16L2551
LOW VOLTAGE DUART WITH POWERSAVE
RTS# output may be used for hardware flow control by setting EFR bit-6 to logic 1. When Auto RTS is selected,
an interrupt will be generated when the receive FIFO is filled to the programmed trigger level and RTS de-
asserts to a logic 1 at the next upper trigger level. RTS# will return to a logic 0 when FIFO data falls below the
next lower trigger level. The RTS# output must be asserted (logic 0) before the auto RTS can take effect. RTS#
pin will function as a general purpose output when hardware flow control is disabled.
• Logic 0 = Automatic RTS flow control is disabled (default).
• Logic 1 = Enable Automatic RTS flow control.
EFR[7]: Auto CTS Flow Control Enable
Automatic CTS Flow Control.
• Logic 0 = Automatic CTS flow control is disabled (default).
• Logic 1 = Enable Automatic CTS flow control. Data transmission stops when CTS# input de-asserts to logic
1. Data transmission resumes when CTS# returns to a logic 0.
4.13 Software Flow Control Registers (XOFF1, XOFF2, XON1, XON2) - Read/Write
These registers are used as the programmable software flow control characters XOFF1, XOFF2, XON1, and
XON2. For more details, see Table 7.
35